Ep-64 R Receiver; Ep-64 H Handheld Transmitter - Fohhn EP-64 P Bedienungsanleitung

2.4 EP-64 R Receiver

The receiver EP-64 R is developed for permanent installation in
the Easy Port and ADESSO systems. It has 64 frequency settings
in a range between 790–814 MHz (channel 61-63). The channels
are quick and easy to change from the front. The two receiver
aerials (true diversity) are integrated in the speakerhousing and
are not visible from the outside. The integral receiver switches on
automatically when the speaker system is switched on.
volume control LCD display
LCD display
(1) AF signal
(2) RF signal
(3) Display for SCAN mode
(4) Display for set Freq. Mode
(5) Main display
(6) Diversity display (A or B antenna)
(7) Battery display for the transmitter
F
Setting the frequency on the receiver
There are two ways you can set the correct frequency:
1. Scan function
Automatic search function / transmitter recognition. The transmitter
must be switched on:
-> Switch on the receiver (Press the power ON/OFF button)
-> Press the Set button for 3 seconds -> "FREQ" flashes on the
display (4)
-> Press the Set button again -> "SCAN" flashes on the display (3)
-> Press the up or down button to start the scanning process. The
receiver searches up or down between 790 MHz and 814 MHz for the
correct frequency of the nearest active transmitter.
-> Press the Set button briefly to store the correct frequency.
2. Manual search
-> Switch on the receiver (press the power ON/OFF switch)
-> Press the Set button for 3 seconds -> "FREQ" flashes on the
display (4)
-> In the frequency list, search for the correct frequency (see
operating instructions for the EP-64 set) for the corresponding
setting, e.g. transmitter: group A / channel 1 => receiver 790.875
MHz
-> Press the up or down button to select the correct frequency. The
frequency increases and decreases in increments of 0.125 MHz.
-> Press the Set button briefly to store the correct frequency.
12 | EP-64 Set
up/down button
set button power ON/OFF switch

2.5 EP-64 H Handheld Transmitter

The EP-64 H handheld transmitter operates with 64 reversible
frequencies in the 790 to 814 MHz UHF carrrier frequency range.
EP-64 H features a clear display, which shows the adjusted carrier
frequencies and battery status. Additionally, you can lock the set
carrier frequency and ON/OFF switch against operating errors.
EP-64 H contributes an integrated antenna.
The microphone head features a built-in wind and pop filter to
reduce wind and breath noise and provides low handling noise
sensitivity, high gain before feedback and brilliant sound quality.
The solid metal body supports an optimal handling.
(11)
(12)
POWER
MUTE
(11) OFF / POWER
POWER
POWER to transmitter is on.
OFF
Power to transmitter is off.
(12) Mute
The signal delivered by the microphone is muted while
power and the RF carrier frequency remain on. This prevents
the receiver from responding to interferences from other
transmitters.
(13) Battery Compartment
Battery compartment to insert supplied size AA 1.5 V dry
batteries or a standard 1.2 V rechargeable batteries, >2100
mAh size AA.
Refer to section 3.2
(14) Frequency Label
The label on the stem of the transmitter indicates the available
carrier frequencies and approval information.
(15) Display
Shows adjusted channel as well as the current battery status.
The 64 channels are grouped into A to D with 16 channels 1 to
16 each.
(13) (16) (17) (18)
(14) (15)