Specifications - Autotek A55800 Benutzerhandbuch

MODEL
CHANNELS
CIRCUIT
OUTPUTPOWER RMS 13,8 V
Watts on 4 / 2 Ohm (CH 1 / 2 / 3 / 4)
Watts on 4 Ohms bridged (CH 1/2 and CH 3/4)
Watts on 4 / 2 / 1 Ohm (Subwoofer Channel CH5)
OUTPUTPOWER MAX. 13,8 V
Watts on 4 / 2 Ohm (CH 1 / 2 / 3 / 4)
Watts on 4 Ohms bridged (CH 1/2 and CH 3/4)
Watts on 4 / 2 / 1 Ohm (Subwoofer Channel CH5)
Frequency Range –3dB
Damping Factor
Signal-to-Noise Ratio
Channel Separation (CH 1+2 / 3+4)
THD&N
Input Sensitivity
Input Impedance
Input Selector
CH 1 & CH 2
X-Over Modes
Various Highpassfilter
CH 3 & CH 4
X-Over Modes
Various Highpassfilter
CH 5 (Subwoofer Channel)
X-Over Mode
Various Lowpassfilter
Subsonicfilter
Bass Boost @ 45 Hz
Bass Remote
Fuse Ratings
Dimensions
Width & Height
Length
Technical specifications are subject to change! Errors are reserved!
For damages on the vehicle and the device, caused by handling errors of the device, we can't assume liability.
All AUTOTEK Amplifiers are tagged with a individual serialnumber, which will be registerd for statistic and service conditional
purposes.
All Crunch Amplifiers are tagged with a E-Certification Number and also a CE-Certification Mark. Thereby these devices are
ceritified for a use inside vehicles inside the European Union (EU).
The warranty conditions comply to the common consumer acts of the European Union (EU).
S P E C I F I C A T I O N S
A5800
5
CLASS A/B
Analog
4 x 75 / 4 x 125
2 x 250
1 x 150 / 225 / 300
4 x 150 / 4 x 250
2 x 500
1 x 300 / 450 / 600
20Hz - 30 kHz
200
90 dB
74 dB
0,1%
5 - 0.2 V
47 kOhm
CH4 / CH5
Full - HP
10 - 150 Hz
Full - HP
10 - 150 Hz
LP
30 - 150 Hz
15 - 55 Hz
0 - 12 dB
•
1 x 70 A
237 x 55 mm
560 mm
2 4
25
26