Dirt Devil m 8020 r1 antiinfective R1 Bedienungsanleitung Seite 28

3 Operating
1
2
2
1
1
28
1. Push on the desired nozzle,
or Chapter 2.3, "Using other nozzles (accessories)".
2. Remove the cable, by holding the plug, until the yellow
mark is reached (Fig. 11/1).
WARNING:
If the red mark (Fig. 11/2) is visible, use the cable retract
button (Fig. 12/3) to draw in the cable again up to the
yellow mark. Otherwise the cable can break off. There is
Fig.11
a risk of electric shock.
3. Switch on the cylinder vacuum cleaner using the on/off
switch (Fig. 12/1).
3
4. Turn on the suction using the suction controller
(Fig. 12/2).
Fig.12
5. Adjust the carpet/hard floor switch (Fig. 13) depending
on the type of flooring:
- Hard floor (Fig. 13/A)
A
Laminate flooring, tiles, PVC flooring, etc.
- Carpet (Fig. 13/B)
Long and short pile carpets, runners, etc.
B
6. To vacuum, pull the cylinder vacuum cleaner behind
you like a sledge. Observe the corresponding
Fig.13
recommendations of the flooring manufacturer.
NOTE:
You can quickly reduce the suction power with the
secondary air controller (Fig. 14/1) if less suction power
is required or e. g. to release objects that have been
sucked in.
Fig.14
Chapter 2.2, "Assembly"