Room Temperature, Ventilation And Cavity Depth; Ambient Temperature; Installation Location; Connecting The Appliance - NEFF G..14 Serie Gebrauchsanleitung

en
Room temperature,
ventilation
and cavity depth

Ambient temperature

The appliance is designed for a specific
climate class. Depending on the
climate class, the appliance can be
operated at the following temperatures.
The climate class can be found on
the rating plate. Fig. 8
Climate class
SN
N
ST
T
Note
The appliance is fully functional within
the room temperature limits of the
indicated climatic class. If an appliance
of climatic class SN is operated at colder
room temperatures, the appliance
will not be damaged up to a temperature
of +5 °C.
Ventilation
The air on the rear panel of
the appliance heats up. Conduction of
the heated air must not be obstructed.
Otherwise, the refrigeration unit must
work harder. This increases power
consumption. Therefore: Never cover
or block the ventilation openings!
22
Permitted ambient
temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C
Cavity depth
A cavity depth of 560 mm is
recommended for the appliance.
If the cavity depth is smaller – at least
550 mm – the energy consumption
increases slightly.

Installation location

Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e. g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable,
use a suitable insulating plate or observe
the following minimum distances to a
heat source:
3 cm to electric or gas cookers.
■
30 cm to an oil or coal-fired cooker.
■
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance is switched on.
During transportation the oil in
the compressor may have flowed into
the refrigeration system.
Before switching on the appliance for
the first time, clean the interior of
the appliance (see chapter "Cleaning
the appliance").