Troubleshooting - AEG S33400CSS0 Benutzerhandbuch

• when all the ice has melted, clean and
wipe the cabinet dry, then put the
drainage channel back in place.
• switch on the cabinet and replace the
frozen foodstuff.
It is recommended to operate the ap-
pliance at the highest position of the
thermostatic control for some hours
so that it can reach the sufficient stor-
ing temperature as soon as possible.

7. TROUBLESHOOTING

CAUTION!
Before troubleshooting, discon-
nect the power supply.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual.
Problem
The appliance is
noisy.
The compressor op-
erates continually.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Possible cause
The appliance is not sup-
ported properly.
The Temperature regula-
tor may be set incorrectly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
ENGLISH
Never use sharp metal tools to
scrape off frost from the evapo-
rator as you could damage it. Do
not use a mechanical device or
any artificial means to speed up
the thawing process other than
those recommended by the
manufacturer. A temperature rise
of the frozen food packs, during
defrosting, may shorten their
safe storage life.
There are some sounds during
normal use (compressor, refriger-
ant circulation).
Solution
Check if the appliance
stands stable (all the four
feet should be on the
floor).
Set a warmer temperature.
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
31