Replacing The Lamp; Closing The Door - AEG SKS81000F0 Benutzerinformation

Problem
The temperature in the
appliance is too low/high.
The temperature in the
refrigerator is too high.
Upper or lower square is
shown in the temperature
Display.
dEMo appears on the
Display.

Replacing the lamp

The appliance is equipped with a longlife LED interior light.
Only service is allowed to replace the lighting device. Contact your Service Center

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
Possible cause
Products prevent that water
flows into the water collector.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
An error has occurred in meas-
uring the temperature.
The appliance is in demonstra-
tion mode (dEMo).
What to do if...
Solution
Make sure that products do not
touch the rear plate.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
47