Rear Panel Connections - Block A100 Bedienungsanleitung

REAR PANEL CONNECTIONS

1 2
4
1. POWER SWITCH: Switches mains power on/off to internal
components, however please note that mains power is still
applied to this unit even though this switch may be off.
2. FUSE HOLDER: fitted with 20mm T 4A fuse inside.
" IMPORTANT:"
Remove the mains plug from the mains socket before attempting
to check/ replace the fuse located on this fuse holder.
3.
MAINS CABLE INLET JACK: Please ensure that the input cable strain relief
bush is intact and has not been damaged.
4.
WARNING ICONS: Please be aware that this unit contains high voltages,
and should not be opened, please refer to page 2 of this manual.
3 5
FUSE: T4A 250V
6
8
8
5.
LOUDSPEAKER A OUTPUTS . Please ensure that +/- connections are
made properly between rear of the amplifier and loudspeakers. Ensure
wires are not frayed or touching.
6.
LOUDSPEAKER B OUTPUTS . Please ensure that +/- connections are
made properly between rear of the amplifier and loudspeakers. Ensure
wires are not frayed or touching.
7. ANALOG SIGNAL INPUT JACK.
8. BALANCE CONTROL KNOB.
P16
8
R Balance
L
Model: A 100
Hi-Fi Stereo Power Amplifier
Power Rating: AC 230V 50Hz
Max Power Consumption: 500W
7