Binding; Getting.started - XciteRC RTR-Rennboot X-Tide micro Bedienungsanleitung

Binding · Getting started

BINDING:

The.2.4.GHz.receiver.of.X-TIDE.MICRO.must.be.once.„connected".with.a.suitable.transmitter,.the.so-called.
„binding".procedure..This.ensures.that.the.receiver.establishes.a.connection.only.with.this.transmitter.and.the.
model.can.be.operated.without.interference..This.process.can.be.repeated.any.time.
The.transmitter.and.receiver.of.the.X-TIDE.MICRO.are.already.bound.so.that.you.can.start.flying.immediately..
Should.a.rebind.gets.necessary.(eg..after.a.transmitter.change),.proceed.as.follows:
•. Make.sure.that.no.other.2.4.GHz.network.(eg..WLAN.or.other.transmitter).sends.nearby.
•. The.distance.between.transmitter.–.e.g..X-TIDE.MICRO.should.be.maximum.one.meter.
• Note:.the.X-Tide.micro.must.be.in.the.water.so.that.the.remote.control.system.is.activated!
•. Switch.on. the.transmitter.. The. green. FREQUENCY.. LED. flashes.for. about. 5. seconds.. During.these.5.
seconds,.turn.on.the.boat..When.the.LED.lits.permanently.green,.the.transmitter.is.now.bound.to.the.
X-Tide.micro.
•. If.you.still.cannot.control.the.boat,.repeat.the.process.
Getting started
Before.you.begin.please.check:
•. Insert.the.included.soft.rubber.protection.on.the.boot.tip..Pay.attention.to.the.short.pin,.it.must.engage.in.
the.provided.hole.on.the.underside.of.the.hull..This.is.especially.useful.if.you.operate.with.several.boats.at.
once,.or.eg..in.a.swimming.pool.in.order.not.to.damage.it.
• NOTE:.The.X-Tide.micro.needs.due.to.their.small.size.a.calm.water.surface..Do.not.drive.in.heavy.seas!
• WARNING:.Only.start.with.a.sufficiently.full.transmitter.batteries.(rechargeable.batteries).and.fully.
charged.drive.battery.–.crash hazard!
•. Check. all. parts. for. damage. and. dirt.. Replace. any. damaged. parts. and. clean. the. model,. because. dirt.
increases.the.weight.and.therefore.can.degrade.the.flying.qualities..
•. Switch. on. the. transmitter.. The. red. POWER. LED. lits. and. the. green. FREQUENCY. LED. flashes.. Wait. a.
moment.until.the.green.FREQUENCY.LED.lits.permanently,.then.connect.the.drive.battery.with.the.boat..
Release.upper.hull.by.turning.the.rear.lock.
and.lift.the.back.end.
X-TIDE micro
Place.the.LiIo.battery.in.the.battery.holder..
. WARNING:. Operate. your. boat. only.
with.a.fully.charged.battery.–.loss of con-
trol!.
EN
19