Herunterladen Inhalt Inhalt Diese Seite drucken

BOMANN KG 183 Bedienungsanleitung Seite 30

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Problem
Problem
Problem
Problem
Possible cause
Possible cause
Possible cause
Possible cause
The device is not
Are the ventilation openings clear of
working properly
obstruction?
or at all.
Device cools too
Is the temperature control set properly?
much.
Is the temperature control set properly?
Was the door open for an extended
period?
The food is too
Was large quantity of warm food placed
warm.
in the appliances within the last 24
hours?
The appliance is near a heat source.
Loud noise during
Does the device not stand vertical or
operation.
horizontal?
Is the temperature control set properly?
Water on the bot-
Is the water discharge opening
tom.
blocked?
Is the unit not connected to mains pow-
Light does not
er?
work.
Is the light bulb defect?
The device is not equipped with the conventional grating on the back. The
The sides of hous-
refrigeration cycle takes place in the foaming. The heat exchangers are installed
ing becomes
in the housing covered. The device does not generate cold, but cut the interior
warmly.
heat. This heat must be dissipated through the housing areas.
On days of high humidity, condensation might occur on the outer surface of the
Water on the outer
surface.
device. This is no malfunction; you may simply wipe the water off.
NOTE:
NOTE:
NOTE:
NOTE:
If a problem still persists after following the steps above, please contact your distributor or an author-
ized technician.
Solution
Solution
Solution
Solution
Unblock the ventilation openings, install the
device freely.
Check the temperature setting.
Check the temperature setting.
Open the door only as long as necessary.
Turn the control panel to a colder setting
temporally.
Check the installation location (see "Instal-
lation").
Adjust the feet accordingly.
Liquid flow sounds in the cooling circuit are
normal.
Check the temperature setting.
Clean the water discharge opening with a
pipe cleaner or knitting needle.
Insert the plug properly in the contact
socket. Check the fuse.
Contact a specialist (see "LED light").
14

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis