Installation; Electrical Connection - BOMANN KG 183 Bedienungsanleitung

Conditions for the installation location Conditions for the installation location
Conditions for the installation location Conditions for the installation location
• Sufficient ventilation around the device is necessary in order for the heat to dissipate properly and
to guarantee efficient cooling operation at low power consumption. For this purpose, leave suffi-
cient space around the device.
minimum distance of 7,5 cm between rear side and wall;
-
at least 10 cm on both sides;
-
and on top of the device 10 cm.
-
Leave proper space in front of the device in order to open the door at an angle of 160°.
-
• Only install at a location with an ambient temperature suitable for the climate class of the device.
For information on the climate class, please refer to chapter "Technical Data" or to the rating label
located in the interior or on the rear side of the device.
• Place the device on a steady and safe surface. If the device is not horizontally leveled, adjust the
feet accordingly.
• Install the device for the wall socket to be freely accessible.
• Avoid the installation: Avoid the installation:
Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or any other heat sources;
-
at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be susceptible
-
to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas, fuel, alcohol, paint, etc.) and in rooms which
-
may have poor air circulation (e.g. garages).

Electrical connection

Electrical connection Electrical connection Electrical connection
WARNING WARNING
WARNING WARNING
For your personal safety:
• Do not use an extension cord or an adapter plug.
• Do not, under any circumstances cut or remove the earthing connection from the power cord.
CAUTION: CAUTION:
CAUTION: CAUTION:
In case you disconnect the device or in case of power failure: Wait for 5 minutes before restarting the
device.
• Make sure that the mains voltage to be used matches that of the device. You can find this infor-
mation on the rating label of the device.
• Connect the device to a duly installed protective contact socket.
• Let replace the contact socket by an authorized specialist if this is not suitable for the power plug.

Installation

Installation Installation Installation
6