Replacing The Lamp; Closing The Door - AEG SKZ81800F0 Benutzerinformation

Problem
Water flows on the
rear plate of the re-
frigerator.
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is too
high.
Upper or lower
square is shown in
the temperature Dis-
play.
dEMo appears on the
Display.

REPLACING THE LAMP

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter.

CLOSING THE DOOR

1.
Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
Possible cause
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
An error has occurred in
measuring the tempera-
ture
The appliance is in dem-
onstration mode (dEMo).
ENGLISH
Solution
This is correct.
Set a higher/lower temper-
ature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
Keep pressed approximate-
ly 10 sec. the OK button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly
37