Sharp XL-3000H Bedienungsanleitung Seite 93

3
Within 4 seconds, press the PRESET (
select the programme type.
Each time the button is pressed, the programme type will ap-
pear. If the button is held down for more than 0.5 seconds, the
programme type will appear continuously.
4
Whilst the selected programme type is flashing (within
4 seconds), press the PTY.TI button again.
After the selected programme type has been lit for 2 seconds,
"SEARCH" will appear, and the search operation will start.
Notes:
z If the display has stopped flashing, start again from step 2. If the
unit finds out a desired programme type, corresponding channel
number will flash for about 4 seconds, and then the station name
will flash for 7 seconds, and then will remain lit.
z If you want to listen to the same programmed type of another sta-
tion, press the PTY.TI button whilst the channel number or station
name is flashing. The unit will look for the next station.
z If no station can be found, "NOT FOUND" will appear for 4 sec-
onds.
If you select the traffic programme:
or ) button to
If you select the traffic programme (TP) in step 3, "TP" will appear.
(This does not mean that you can listen to the traffic information at
that time.)
When a traffic information is broadcast, "TA" will appear.
To specify station names and select stations manually:
You can select a station by specifying the name (BBC R1, BBC R2,
etc.) from the stations stored in memory.
Before starting this operation, you must store one or more station
names in memory.
1 Press the TUNER button, and then the BAND button to select the
FM band.
2 Press the PRESET (
3 The station name will be displayed for 3 seconds. Then the dis-
play will change as follows.
or ) button to select a desired station.
ENGLISH
E-23