Technical Data; Closing The Door; Installation - AEG A51700GSW0 Benutzerinformation

14

Technical data

Problem
Green indicator flashing

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a location where the ambient temperature
corresponds to the climate class indicated on the rating plate of the appliance:
Climate class
SN
N
ST
T
Possible cause
Temperature Regulator is not on Check the Temperature Regulator
Temperature sensor problem
Height
Width
Depth
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Call the service personnel
1250 mm
545 mm
640 mm
18 h
230 V
50 Hz
Ambient temperature
Solution