AEG FAVORIT 88082 VI0P Benutzerinformation Seite 30

30 www.aeg.com
7.2 Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the
appliance. The appliance is in setting
mode when the display shows 2 horizon-
tal status bars. If the control panel does
not show this condition, press and hold,
at the same time, Program and Extra-
Hygiene until the display shows 2 hori-
zontal status bars.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Press Program again and again until
you see in the display the number of
the programme you want to set. The
programme number flashes. If you
want you can set the applicable op-
tions.
4. Close the appliance door, the pro-
gramme starts. The programme du-
ration starts to decrease with steps of
1 minute.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
• The Delay indicator comes on.
3. Close the appliance door. The count-
down starts.
• When the countdown is comple-
ted, the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press and hold, at the same time,
Program and ExtraHygiene until the
display shows 2 horizontal status
bars.
2. Set the programme again.
Cancelling the programme
1. Press and hold, at the same time,
Program and ExtraHygiene until the
display shows 2 horizontal status
bars.
Make sure that there is detergent
in the detergent dispenser be-
fore you start a new programme.
At the end of the programme
The display shows 0:00 and the end indi-
cator comes on.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
If you do not press the on/off
button, the AUTO OFF function
automatically deactivates the ap-
pliance a few minutes after the
end of the programme.
This helps to decrease the ener-
gy consumption,
Important
• Let the dishes become cold before
you remove them from the appliance.
Hot dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.
• There can be water on the sides and
on the door of the appliance. Stainless
steel becomes cool more quickly than
the dishes.