Tools Needed For The Assembly; Your Radio System - Carson X10NT Rock Warrior Nitro Betriebsanleitung

Tools Needed for the Assembly

Modelling knife 300074053
Philips screwdriver
(small and big) 1,5/ 2 /
2,5 mm 300074023
Your Radio System (only for RTR version) Your Radio System (only for RTR version)
Please read the instructions provided with your radio system before
using it.
The servos must be set at the centre position before installation. To
set the servos at a neutral position, turn on the transmitter and recei-
ver. Set the trim levers in the centre position and turn off the receiver,
and then the transmitter. The servos will be in proper neutral position
for installation.
Receiver antenna
500103040_X10NTRockWarriorNitro_L2.indd 17
Instant adhesive 300053339
Hexagonal wrench 500905065
Receiverbattery
Switch
Steering servo
Engine
throttle servo
CARSON X10NT Rock Warrior Nitro 500103040
Needle nose pliers 300074034
Tweezers 300074003
Scissors 500013305
Side cutter 300074035
Transmitter
17
17.02.14 08:04
G