Turn The Power Switch On; How To Control Your Model - Carson X10NT Rock Warrior Nitro Betriebsanleitung

Turn the Power Switch on

Turn the Power Switch on
Pull the transmitter antenna out completely.
The range of the remote control is reduced if the antenna is not The range of the remote control is reduced if the antenna is not
pulled out completely.
CAUTION!
Always turn the transmitter´s
power switch ON first!
Switch on the receiver
• Power switch is on the radio box.
• Fix the receiver antenna and wire (see page 73).
• Put the body on and fix it with the body split pins.

How to Control Your Model

• Raise the tyres off the ground
• Turn the steering wheel to the right and left as far as it will go. The
wheels are to follow the steering direction.
• If the wheels operate in the opposite direction, operate the servo
Reverse switch (ST in position REV).
• To regulate the driving speed, actuate the throttle/brake
- backwards (forward driving,
accelerating) or
- forwards (braking, reversing)
500103040_X10NTRockWarriorNitro_L2.indd 21
ON
CARSON X10NT Rock Warrior Nitro 500103040
8
ON
Neutral
Left
braking, reverse
movement
driving forward,
to give speed
G
Right
21
17.02.14 08:04