Troubleshooting - Carson X10ET Chassis Betriebsanleitung

h. Troubleshooting
Problem
Model doesn´t move
Loss of control
Doesn´t run straight
Doesn´t stop
Doesn´t reverse
Running too slowly
Cause
Transmitter or chassis power switch is not "ON"
Polarity or battery type is wrong
Batteries have run down
Batteries have run down
Antenna is missing or not attached properly
R/C model using same band (frequency) is nearby
Steering trim is not adjusted correctly
Wheel nuts are too lose
Throttle trim is not adjusted correctly
Throttle trim is not adjusted correctly
Batteries have run down
Motor has lost power
Rear wheel nuts are too loose
Dust or foreign objects are inside gears
Correction
Switch on power transmitter and receiver
Check polarity and battery type
Change batteries or charge them
Change batteries or charge them
Attach receiver antenna and screw tight transmitter
antenna
Run model in different area or change crystal
Make adjustment of the trim at the turning knob
Tighten wheel nuts
Make adjustment of the trim
Make adjustment of the trim
Change batteries or charge them
Change to spare motor
Tighten wheel nuts
Turn the power switch „OFF" and clean out gears
CARSON X10ET Rock Warrior 50 040 4038
GB
21