Connection Conditions; Startup / Operation - BOMANN EBK 964 Bedienungsanleitung

Connection conditions

WARNING:
• The installation to the mains supply must conform to the local standards and regulations.
• Improper connection may cause to an electric shock!
• In no event the device should be connected to an extension cord, adapter plug or the like.
• Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet, let install a proper outlet by an authorized speci-
alist.
• Ensure that your mains power corresponds with the specifications of the appliance. The specifications are printed on the rating label.
• Connect the mains cable to a properly installed and earthed wall outlet.
• Guide the mains cable in such a way that it does not get in contact with any hot components of the device. Do not lead it over sharp edges or.
General information about the operation
• The appliance is operated through the buttons on the control panel of the appliance.
• The buttons react to the slightest touch. You do not need to apply any pressure.
• The appliance reacts best when touching the buttons with the fingertips and with dry hands.
• Once a touch has been registered, a brief beep will sound.
• Ensure that the control panel is always clean and dry. Objects or a small liquid film can impair operation.
Selecting the right cookware
Turning the appliance on/off
Press the on/off button on the control panel to turn on the appliance. After turning it on, a beep will sound and all the displays will show "-" or "--". The
appliance is now in standby mode.
NOTE:
• If you do not select a function within one minute, the appliance will switch off automatically.
• The cooking zone can be turned off at any time by pressing the on/off switch.
Turning a cooking zone on/off
• Place suitable cookware onto the cooking zone to be used. Ensure that the surface of the cooking zone and the bottom of the cookware are clean
and dry.
• Select at the control panel the desired cooking zone by the cooking zone selection buttons. The power setting "0" is flashing.
• Set the desired heating setting from 1 to 9 with the (+) or (-) button. First the power setting "5" is displayed. By pressing the (+) or (-) button, the
setting is changed continuously.
• To switch off a cooking zone, select the corresponding cooking zone by the selection button and press the buttons (-) until the power level "0" is
indicated. You can also press the (+) and (-) buttons at the same time to reset the power to setting 0 and the cooking zone will be turned off.
NOTE:
The power settings can be changed at any time during cooking.
Using the timer to turn one cooking zone off
You can use the timer to automatically turn off one cooking zone after a set duration.
• Select the respective cooking zone that you would like to set the timer for. Set the desired power setting with the (+) or (-) button.
• Press the timer button. The minute indication flashes "10" and the timer can be set.
• Make an adjustment of between 1 and 99 minutes with the button (+) or (-).
• With each push of the (+) or (-) button, the set time will change by one minute. By pressing the (+) or (-) button, the set time will be changed in
10-minute increments.
• After setting the timer, the minute indication flashes for a few seconds. A red dot next to the power level indicates that a timer is set for this cooking
zone. The minute indication shows the remaining time.
16 16

Startup / Operation

Only use cookware with a completely even bottom.
The bottom of the cookware should be of the same size as and be centered on the
cooking zone.
To prevent scratches, do not slide the cookware across the cooking zone, but lift it.