Napoleon BIPRO 665 Bedienungsanleitung Seite 15

Problem Possible Causes
Burners will not cross light each Dirty or corroded cross light
other. brackets.
"Paint" appears to be peeling Grease build-up on inside surfaces.
inside lid or hood.
Burner output on "high" setting Lack of gas.
is too low. (Rumbling noise and
fluttering blue flame at burner Supply hose is pinched.
surface.)
Dirty or clogged orifice.
Spider webs or other matter in
venturi tube.
Propane regulator in "low flow"
state.
Infrared burner (if equipped) Ceramic tiles overloaded with
flashes back (during operation grease drippings and build-up.
the burner abruptly makes a Ports are clogged.
loud "whoosh" sound, followed
by a continuous blow-torch type
sound and grows dim.) Burner overheated due to
inadequate ventilation (too much
grill surface covered by griddle or
pan.)
Cracked ceramic tile.
Leaking gasket surrounding the
ceramic tile, or a weld failure in the
burner housing.
Electronic Ignition not working. Unit not connected to power.
Blown Fuse.
Faulty transformer.
Terminals on switch or circuit board
are corroded or loose.
Faulty igniter.
Dirty or corroded electrodes.
Oven and control panel lights not Unit not connected to power.
working
Blown fuse.
Faulty transformer.
Terminals on switch or circuit board
are corroded or loose.
Bulbs blown (oven lights only).
Solution
Clean or replace as required.
This is not a defect. The finish on the lid and hood is
porcelain, and will not peel. The peeling is caused by
hardened grease, which dries into paint-like shards that
flake off. Regular cleaning will prevent this. See cleaning
instructions.
Check gas level in propane cylinder.
Reposition supply hose as necessary.
Clean burner orifice.
Clean out venturi tube.
Ensure lighting procedure is followed carefully. All
gas grill valves must be in the off position when the
tank valve is turned on. Turn tank on slowly to allow
pressure to equalize. See lighting instructions.
Turn burner off and allow to cool for at least two
minutes. Relight burner and burn on high for at least
five minutes or until the ceramic tiles are evenly
glowing red.
Ensure that no more than 75% of the grill surface is
covered by objects or accessories. Turn burner off and
allow to cool for at least two minutes, then relight.
Allow burner to cool and inspect very closely for
cracks. If any cracks are found, contact your authorized
Napoleon dealer to order a replacement burner
assembly.
Contact your authorized Napoleon dealer for
instructions on ordering a replacement burner
assembly.
Plug power cord into a working GFI protected outlet.
Replace fuse located on outlet line of transformer.
Check transformer output – should be 12VAC. Replace
if required.
Clean connections and ensure connectors are pushed
together firmly. Access to circuit board is under
electrical cover on left side of cabinet.
Replace igniter – located under electrical cover.
Clean or replace as required.
Plug power cord into a working GFI protected outlet.
Replace fuse located on outlet line of transformer.
Check transformer output – should be 12VAC. Replace
if required.
Clean connections and ensure connectors are pushed
together firmly. Access to circuit board is under
electrical cover on left side of cabinet.
Replace bulbs as per the instructions in the
maintenance section of the manual.
www.napoleongrills.com
15
EN