Controls On Rear Panel; Satellite Filter - Adam Sub7 Bedienungsanleitung

5. Controls
5.2 Controls on the rear panel
a) Mode
This push button allows you to choose between
• Auto On: woofer starts operation as soon as a musical
signal arrives, and stops after 15 minutes without a
signal.
• Auto Off: the unit is permanently working.
We recommend the "Auto On" position. It minimises
power consumption and makes handling very easy.
b) Subwoofer Phase
With the Phase Switch you can alter the phase of the subwoofer relative
to the satellites. That means to change the polarity of the bass unit.
Depending on the distance between woofer and satellites, either 0° or
180° may be the better position.
We recommend to try out what position sounds better within your
system.
c)

Satellite Filter

The satellites in a system can be driven full range or with a 85 Hz high
pass as recommended by Dolby® laboratories for use in surround set-
ups.
Recommendation: If possible the main signal should go into the
Subwoofer. Connect your satellites to the Subwoofer output, either
via XLR symmetrical or RCA asymmetrical. In many cases, clarity and
dynamic range of the speakers can be improved if they do not reproduce
very low frequencies since they do not have to deliver big amplitudes.
d) Foot Switch
The optional available footswitch switches the suboofer on respectively
off. Please note that by switching it off you also switch off the Satellite
Filter.
10