Intended Use; Optional Accessories - Kathrein CAS 90gr Handbuch

Offset parabolic antennas
Features
■
Reflector made of aluminium, powder coated
■
Feed system support made of galvanised sheet steel,
plastic coated
■
Mast clamp made of sheet steel, hot-dip galvanised
■
Optimal electrical data combined with very compact mecha-
nical dimensions due to offset feed
■
Patented tilt facility at the multi-feed adaptor plate, allows
optimisation of the LNB positions for multi-feed reception
■
Items supplied: Reflector, pre-assembled mast and
feed system support, allen wrench (size 5)

Intended Use

The CAS 90 parabolic antenna is intended solely for the reception of satellite signals and for use only as a domestic antenna.
DIN 4131 specifies that a domestic antenna has no more than 6 m free mast length and a fixed-end moment up to 1650 Nm.
It is unsuitable for mounting on structures that are liable to vibration.
Make absolutely sure that the values for the maximum load listed in the Technical Data (on the last page) are complied with.
If this load is exceeded, parts could break away!
The CAS 90 parabolic antenna is designed for use with a feed system (LNB) for reception of the signals from one satellite position, or
two feed systems for multi-feed applications for reception of the signals from two satellite positions with 3° – 4° or 6° satellite spacing.
When the additional ZAS 90 multi-feed adapter plate is used, the parabolic antenna is also suitable for three feed systems.
The feed systems and instructions for their installation are not included in the scope of supply of the parabolic antenna.
Do not use the parabolic antenna for purposes other than those listed in this manual! Any use other than that
specified above will void the warranty or guarantee.
In particular, never
● modify any of its components or
● fit any components other than those expressly intended by the manufacturer for use with the antenna.
Breach of these rules may lead to the antenna no longer being sufficiently stable and safe!

Optional Accessories

■
ZAS 90 (BN 218684) multi-feed adaptor plate
Installation items 2 and 3 cannot be mounted
at the same time. To find out the elevation values
for your location by means of an azimuth/elevation
calculation, go to
sat/satpos/eng_satpos_suche.cfm.
http://www.kathrein.de/content/
■
Without additional components, two universal feed sys-
tems to receive the signals of satellites 3° or 4° (e.g. ASTRA
19.2°/23.5°) or 6° apart (e.g. ASTRA/EUTELSAT-HOTBIRD)
can be mounted on the boom
For any other combination, the ZAS 90 (BN 218684) multi-
feed adaptor plate (see below) is required in addition.
11 / 36
CAS 90gr 20010033
CAS 90ro 20010034
CAS 90ws
20010035