X3-Atlas / X3-Cronos; Features And Operational Controls - Hifonics X3-ATLAS Bedienungsanleitung

Soundsystem

Inhaltsverzeichnis

Verfügbare Sprachen

LINE INPUT

The LINE INPUT RCA jacks must be connected with the RCA output jacks of the headunit.

The optional BALANCED INPUT is unlike the regular RCA-cables insusceptible against interspersion and interferences of the

vehicle's electronics. You need therefor a Balanced-Line-Transmitter with a special cable, which can be connected between the

head unit and the amplifier. The Balance-Line-Transmitter is not included in delivery.Never use the Balanced-Input and the

RCA-Inputs at the same time.

The EXTENDED BASS CONTROL controllers allow a extensive adjustment of the bass frequencies.

The SUB BOOST controller defines the bass bosst from 0 to 18dB. With the FREQ RANGE controller you are able to adjust,

on which frequency the bass boost (SUB BOOST) is effictive. The range goes from 20 to 80 Hz.

With the Q CONTROL controller defines the Q-Factor of the crossover continuously, so that

the playback quality of the cut-off frequency can be adjusted. Thereby you are able to adjust

perfect transitions between the loudspeakers.

• WIDE

Q-Factor of Q 0,3 (arrow left below) = very wide frequency range.

• NARROW

Q-Factor of Q 1,0 (arrow right below) = very narrow frequency range.

• Q 0,5

LINKWITZ-REILLY (Standard-setting, 12 o'clock position).

• Q 0,7

BUTTERWORTH (3 o'clock position)

ONLY X3-ATLAS: The X-OVER MODE switch selects the required operation mode of the amplifier.

In the LP-Mode (Low Pass mode) you are able to limit the frequencies to above or below with the LOW PASS or SUBSONIC

controller.

In the FULL-Mode a full range signal will be provided to the speakers. The controllers PHASE, LOW PASS, SUB SONIC and

the BASS REMOTE are without function.

The OPERATION MODE switch selects the required operation mode of the amplifier.

In the SLAVE-Mode the amplifier works as a SLAVE amp, this means only the audiosignal of the MASTER amp will be amplified.

All controllers on the SLAVE Amp are without function and will be assumed by the MASTER amp.

In the MASTER-Mode all controllers are active.

NOTE: By using only one amplifier, the Mode-Switch must set to the position MASTER.

The PHASE controller allows to adjust the phasing between 0° and 180°. Thereby you are able to adjust the subwoofer

perfect to the vehicle's acustics.

The LEVEL controller adjusts the input sensitivity of the amplifier to align the audio signal from the head unit.

The input sensitivity is adjustable from 9 to 0.2 Volts.

The SUBSONIC controller (Subsonicfilter) limits the ultralow and not hearable frequencies of the audiosignal to below, to avoid

a mechanical and electical overloading on the subwoofer. The range is adjustable from 15 to 55 Hz and depends on the size

of the subwoofer. NOTE: If this controller is turned to a higher value than the LOW PASS controller, no sound is hearable.

The REMOTE IN port is for the cable of the enclosed bass remote controller and only to use in the LP/BP mode. With this bass

remote controller, you are able to adjust the bass level e.g. out of the driver's seat. Please use only the enclosed bass remote

controller and cable.

The REMOTE OUT port is suitable to connect the bass remote link cable of an additional amplifier of the HiFONICS X3 Series

(only in MASTER-Mode). Thus to this, you are able to control several amps with only one bass remote. Attend Page 23.

The LOW PASS controller adjusts the cut-off point of the frequency range to above. The cut-off frequency is continuously

adjustable from 40 Hz to 250 Hz.

POWER/PROTECT

If the POWER LED lights up, the amplifier is ready for operation.

If the PROTECT LED lights up, a malfunction is indicated. Attend in this case the chapter TROUBLE SHOOTING.

The MASTER OUTPUT/SLAVE INPUT jacks are suitable to connect an additional amplifier in MASTER/SLAVE mode.

Attend therefor the chapter Interconnection Example: MASTER/SLAVE on page 21.

The LINE OUT RCA jacks provide a linear audiosignal to supply an additional amplifier.