Display Information; Radio Functions - AEG AR 4029 DAB Bedienungsanleitung

English
34
EON TA The unit can receive RDS EON data. EON means
the transmission of additional programme
information within a station group. In the event of
a traffic announcement (TA), it will switch within a
station group from a non-traffic broadcast to the
corresponding traffic radio station of the station
group.
DX: The unit attempts to receive the EON TA
information from a receivable station and thus
to improve the reception quality.
LO: This prevents switching to a programme
with too weak a signal level.
TA VOL Traffic Announcement Volume
REG Some stations split their programme at certain
times into regional programmes with different
content.
ON: Only the regional programmes of the
station are played.
OFF: National programmes are also played.
Loudness Function
Press and hold /LOU/BND (15) to activate the Loud-
ness function. LOUD ON is displayed. The Loudness
function enhances the bass frequencies.
Press and hold /LOU/BND (15) again to deactivate
the Loudness function. LOUD OFF is displayed.
NOTE:
The loudness function cannot be applied in the BT
AUDIO mode. If necessary, change the sound settings
on your mobile phone.
Sound Settings
Repeatedly press TA/EQ (22) to cycle through the set-
tings FLAT, CLASSICS, POP M, ROCK M or DSP OFF.
The selected setting is displayed.

Display Information

Repeatedly press DSP (24) to cycle through the following
display information:
Time (is automatically set if RDS reception is enabled), radio
station, programme type, frequency of the currently set radio
station, information on file names (only during playback of a
MP3 or WMA file).
NOTE:
If there is no corresponding information, PTY NONE is
shown on the display.
If the information is too long for the display, it is dis-
played as scrolling text.
Setting the time manually (in Radio Mode)
If the time should not be set automatically, proceed as fol-
lows:
Press the button DSP (24) for a short while until the time
appears on the display.
Keep the DSP button (24) pressed until the time flashes
on the display.
Use the button (7) to set the minutes.
Use the button (13) to set the hours.
Reset Radio
To reset the unit to default settings press RESET (29) with a
pointed object, i.e. pen.
Reset the unit when:
using it the first time after all cabling is done,
malfunctions of buttons occur,
error messages are displayed.

Radio Functions

Set RADIO Mode
Repeatedly press MODE/PAIR (17) until frequency and
band are displayed.
Select Frequency Band
/LOU/BND (15) to toggle between FM1, FM2,
Press
FM3 and AM. The selected frequency band is displayed.
Auto Search
Press (7) or (13) to start auto search, SEARCH is
displayed. Search stops if a station is found.
Manual Search
Press and hold (7) or (13) until MANUAL is displayed.
Press (7) or (13) to step through the FM frequency
band in steps of 0.05 MHz and 9 kHz for AM until the
desired frequency is displayed.
After two seconds idling the unit returns to auto search. The
display shows AUTO.
Save Station
For each frequency band 6 station presets are available.
Press and hold the desired numeric button (2-4, 18, 23,
26) approx. 2 seconds to save the current station. A beep
can be heard after successful storage (except setting to
BEEP OFF).
Access Saved Station
Press /LOU/BND (15) to select the desired frequency
band.
Press one of the numeric buttons (2-4, 18, 23, 26) to ac-
cess the respective station.
Auto Save
Press /LOU/BND (15) to select the desired frequency
band.