ABC Design Turbo 4S Bedienungsanleitung Seite 12

7. Fitting and removing the guard rail
a. Fit the guard rail by inserting it in the plastic mounts on both sides.
b. To remove the guard rail from the pushchair, press in the buttons on both sides and pull the guard rail off
away from the pushchair.
c. To adjust the height of the guard rail, press and hold down the buttons on each side and push the bar up
or down.
8. Adjusting the leg rest
To adjust the leg rest, press in the buttons on both sides and then adjust the height.
Let go of the buttons again so that the leg rest clicks into place.
9. Fastening the harness
a. To fasten the harness, bring the top two plastic catches together and interlock them.
b. Then insert the interlocked catches into the bottom part of the fastening.
Adjust the harness to a setting where the baby is held in the correct position.
10. Unfastening the harness
To open the harness, press the button on the side.
CAUTION: Always use the shoulder harness and lap belt together.
11. Adjusting the backrest
To adjust the backrest, pull the retainer on the rear of the backrest upwards and then adjust the height.
When you have reached the required position, let go of the retainer to allow the backrest to remain in that
position.
12. Adjusting the handle
Push the button upwards to adjust the height of the handle.
When the handle is at the required height, let go of the button again so that the handle will remain locked in
this position.
13. Removing the sun canopy
Undo the zip fastener on the side of the canopy.
14. Folding the pushchair
To fold the pushchair, bring the handle to its lowest position as described in point 12, holding the button (1)
down as you do so.
Now rotate the knob (2) to the left and push the handle down.
Now you can fold up the pushchair.
Note: To unfold the pushchair, follow the instructions in point 1 "Opening the pushchair".
CAUTION: Ensure that all the catches are engaged before use.
EN - 07