Setting Up A Bluetooth Connection With Mobile Devices - Omnitronic VFM 208AP Bedienungsanleitung

10
With the button [
• indication "RANDOM": the titles are played in random order (model 212AP and 215AP)
• indication "ONE": continuous repeat of the selected title indication
• indication "FOLDER": continuous repeat of the selected folder (model 212AP and 215AP)
• indication "ALL": continuous repeat of all titles of the data carrier (basic setting)
11
To remove a USB device, disconnect it from the USB port. To eject a memory card, slightly press it into
the slot until it comes out and can be removed. Prior to removing a device, always terminate the
playback with the buttons [►II] or [ ]. Otherwise damage or loss of data may occur.
REGARDING THE REMOTE CONTROL
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery contacts
prevents the battery from being discharged during storage. Prior to the first operation remove the foil from the battery
support on the rear side of the remote control. Otherwise operation of the remote control is not possible.
• If the range of the remote control decreases (10 meters as a maximum), replace the battery.
For this purpose, on the rear side of the remote control press the small bar with the groove
to the right and at the same time remove the battery support. For operation, one 3 V button
cell type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.

Setting up a Bluetooth Connection with Mobile Devices

The audio player features a Bluetooth receiver allowing you to stream music wirelessly from your mobile
devices such as smartphones, tablets and notebooks.
1
Press the [MODE] button (repeatedly) until the display indicates "
enter the pairing mode.
2
Activate the Bluetooth function at the Bluetooth source and start the device scan. Select "
from the list and connect the devices. Once the devices are paired, the audio player's display indicates
CONNECTED
" ".
3
Now play music at the Bluetooth source as you normally would and the sound will come out of the
speaker system.
4
The Bluetooth source may also be operated via the audio player. To interrupt or continue the playback,
press the button [► ].With the buttons [
], you can activate random play and repeat functions.
.
] and [
BLUETOOTH"
] you can skip titles in forward or backward direction.
24
. The audio player will
OMNITRONIC
"