Operation; Audio Player Operation - Omnitronic VFM 208AP Bedienungsanleitung

7 7 7 7

OPERATION

1
Prior to switching on, turn the control MASTER LEVEL to minimum to avoid a possible switching-on
noise. Then switch on the speaker system with the power switch. The POWER indicator lights.
2
Turn up the control MASTER LEVEL so that the mixing ration of the signal sources can be adjusted in
an optimum way.
3
Use the button LINE/MP3 to define which signal source is mixed to the master signal: button pressed:
signal of the built-in audio player, button not pressed = signal of the jacks LINE INPUT or AUX (model
208A/AP and 210A/AP).
4
Adjust the desired volume ratio for the signal sources with the level controls MIC LEVEL and LINE/MP3
LEVEL.
5
Adjust the desired sound with the tone controls. By adjusting the tone controls, the high frequencies
(control HI) and the low frequencies (control LOW) can be boosted or attenuated. With the controls in
mid-position, the frequency response is not affected.
6
Adjust the definite level of the overall volume with the control MASTER LEVEL. In case of overload, the
CLIP indicator lights up. In this case, reduce the volume correspondingly.
7
When operating the speaker system, please make sure that the loudspeakers always sound well. When
distortions can be heard, either the amplifier or the loudspeakers are overloaded. Overloads can quickly
lead to amplifier or speaker damage. In order to avoid damage, please reduce the volume immediately
when distortions can be heard. When speaker systems are destroyed by overload, the guarantee
becomes void. Always check the sound pressure level with a meter in order to keep to the threshold.
8
After operation, set the control MASTER LEVEL to minimum, then switch off the speaker system with
the power switch. The power indicator extinguishes.

Audio Player Operation

For models VFM-...AP with integrated audio player only. Due to the construction of models 208AP and
210AP, the player's functionality is slightly smaller.
The audio player can either be operated via the buttons on the front panel or via the remote control. When
actuating a button, always direct the remote control towards the sensor. There must be no obstacles
between remote control and the sensor. If the range of the remote control decreases, the battery is probably
exhausted and must be replaced.
1
Engage the button LINE/MP3 to assign the signal of the audio player to the master signal.
2
Insert a USB device into the USB port and/or a memory card into the card slot.
3
After loading a data carrier, the total number of titles will be indicated. Press the button [►II], to start
playback. The display indicates "► ". During playback, the display indicates the elapsed time of the
current title in minutes and seconds. Additionally, the file name will be scrolling across the display
(model 212AP and 215AP).
4
Adjust the desired volume for the audio player with the LINE/MP3 LEVEL control. With the buttons [
and [ ] on the remote control it is possible to adjust the internal volume level of the audio player.
5
To interrupt the playback, press the button [► ] or [ ]. The display indicates " "or " ".
6
By short actuation of the buttons [
long actuation of the buttons, fast forward and reverse is activated.
7
For direct selection of a title with the numerical keys [0-9] on the remote control, enter its number.
8
For muting the sound, press the button [
the button once again.
9
Short repeated actuation of the button [EQ] selects an equalizer setting: "BASS", "POP", "ROCK", "JAZZ" ,
"CLASSIC" or "COUNTRY"; when set to "NORMAL", the frequency response is not affected (models 208AP
and 210AP offer five setting options "EQ00-05").
] and [ ] you can skip titles in forward or backward direction. By
] on the remote control. To switch on the sound again, press
23
]