Before First Time Use; Charging The Battery - Peaq PPA40BT-B Bedienungsanleitung

ENGLISH

Before first time use

• Read this user guide carefully to
avoid damages or injuries due to
improper use. Pay special attention
to the safety instructions. Keep the
instructions for future reference and
include them when transferring the
device to third persons.
• The device must be charged be-
fore the first use. Please refer to the
chapter "Charging the battery".
• Carefully
materials and check the device for
completeness and completeness.
Do not use a damaged device.
• Pair the speaker with a Bluetooth
AV source or Bluetooth
phone first. Please refer to the chap-
ters "Pairing".
• The Bluetooth
PPA40BT-B.
Operation
TURNING ON/OFF
To turn the speaker on, press and
hold the On/off switch
2-3 seconds. The Bluetooth
LED flashes in red and blue. Press
the On/off switch
turns itself off.
20
_PPA40BT-B_180112_V02_HR.indb 20
remove all packaging
mobile
®
Speaker ID is
®
for approx.
button
®
until the speaker
ADJUSTING THE VOLUME
Press the button
volume.
Danger! Excessive sound
pressure
and headphones can cause
hearing loss. If you listen to loud mu-
sic for a long time, your hearing may
be impaired. Set to a moderate vol-
ume.

Charging the battery

1. Connect the USB cable (included)
to the speaker.
2. Connect the other end of the USB
cable to the USB port of the com-
®
puter or a USB-charger.
3. During charging the control LED of
the power button shines continu-
ously red.
Note
During the battery charging process
the speaker can be operated. It will
take approx. 4 hours to fully charge
the battery.
LED Status
Power LED (color: red)
LED shines continuously: Battery
charging.
• LED flashes in red: Battery level is
lower than 20%. Battery must be
re-charged.
• LED turns off: Battery charging
complete.
or to adjust the
from earphones
12/1/18 8:15 pm