Prescribed Use - Conrad PS-1 Bedienungsanleitung

Introduction
Dear customer,
we thank you for your acquiring these pocket scales.
By acquiring this product you have purchased a product which has
been manufactured according to the state of technical development
today.
We kindly request the user to respect this operating manual to pre-
serve this condition and to ensure safe operation.
For more inquiries contact or consult our technical
advisory service.
Germany: Tel. 0180/ 5 31 21 17 or 09604/ 40 88 45
Fax 09604/ 40 88 44
e- mail: tkb@ conrad. de
Mon. - Fri. Hours 8.00 a.m. to 6.00 p.m.
Austria: Tel. 0 72 42/ 20 30 60 · Fax 0 72 42/ 20 30 66
e- mail: support@ conrad. at
Mon. - Thu. Hours 8.00 a.m. to 5.00 p.m.
Fri. Hours 8.00 a.m. to 2.00 p.m.
Switzerland: Tel. 0848/ 80 12 88 · Fax 0848/ 80 12 89
e- mail: support@ conrad. ch
Mon. - Fri. Hours 8.00 a.m. to 12.00 a.m.,
1.00 p.m. to 5.00 p.m.

Prescribed Use

The prescribed use includes the weighing of objects up to a weight
of 200g. The operation is only admissible in a dry surrounding,
contact with moisture is to be avoided. As voltage supply only 3
micro batteries (type AAA) may be used.
Any use other than the one described above dama-
ges the product. Moreover, this involves dangers
such as e.g. short-circuit, burns, etc. No part of the
product may be opened, modified or rebuilt!
12
Please note that weighing range of the scales incl. container is
200g. Therefore it is recommendable to use a light container.
Calibration (CAL)
In order to ensure the maximum precision of the scales for the longest
period of time possible it is necessary to recalibrate it regularly but
above all after abrupt changes of temperature and mechanical stress.
For calibrating do as follows:
- Switch on the scales by pressing the switch-on key (2). Wait app.
1.5 minutes until the scales are stable.
- Press the unit key (4) and keep it pressed until the weight display in the
LCD (3) starts flashing. In the LCD-display (3) is now shown "100,0".
- While the weight display "100,0" is flashing in the LCD (3) press
the TARE-key (6) until "AL O" is displayed.
- Place now a optionally available 100g calibrating weight in the
middle of the scale pan (1).
- Now "AL F" is displayed. Press now the TARE-key (6) to get back
to the normal weighing mode. The calibration is completed when
after the stabilisation in the LCD (3) the weight of the calibrating
weight (100g) is displayed.
- Remove the calibrating weight from the scale pan (1) and switch off
the scales at the switch-off key (5) to leave the calibrating programme.
In case of a calibration error or when using a wrong cali-
brating weight "AL E" appears in the LCD (3). In this
case the calibration must be repeated.
Switching off the Scales
- The scales can be switched off by pressing the switch-off key (5).
- The scales are equipped with a "Auto Shut OFF-Function" to save
battery capacity. This function switches off the scales after app.
2.5 min. of operation.
17