Operation Pole Hedge Trimmer - Okay ATHS 4014 Gebrauchsanweisung

• When the battery is at low voltage, the gardening tool
switches off automatically. In this case, the battery
must be charged.
• The lithium ion battery must be charged before long
breaks in use, e.g. before winter storage.
• When the battery is fully discharged, charging time
is 5 hours.
• The lithium ion battery can be charged whatever its
current state of charge, and charging can be interrup-
ted at any time, without damaging the battery (there is
no memory effect).

Operation pole hedge trimmer

WARNING: Read and understand this owner's manual
before operating Pole Trimmer. Make certain you read
and understand all Safety Warnings of this manual.
Improper use of this Pole Trimmer can result in severe
injury or death from fire, electric shock, or body contact
with moving parts.
Pivoting the Power Head
Always remove the battery before inspection and adjust-
ment work.
The Pole Trimmer is equipped with a power head that
pivots. The power head has a spring-loaded button that
allows it to be locked into several different positions
within its 135-degree rotation. Before connecting the Pole
Trimmer to the electrical supply, make sure the power
head is locked into position. Do this by trying to rotate the
power head in either direction. The power head should
be locked in position and should not rotate. To pivot the
power head, follow the instructions below.
1. Push the round button located on the side of the pivot
bracket. The button is spring-loaded, so you will feel
some resistance when pulling it out.
2. Grasp the power head motor housing and rotate the
power head to either of the 6 positions.
3. Release the round button.
It should snap back into its seated position. If it does not,
rotate the power head back and forth slightly until the but-
ton snaps back into its seated position. The power head
is now locked into position and ready for use.
Adjusting telescoping pole
Always remove the battery before inspection and
adjustment work.
Rotate the collar (1) counter clockwise ( ) to loosen.
Push poles towards each other to shorten the pole or pull
away from each to lengthen the pole.
Note: Extend the pole only to the length required to reach
the cut hedges or shrubs.
When the desired length is achieved, rotate the collar (1)
clockwise ( ) to secure.
Switching on/out
15
• Press with your thumbs the stopping button (9) on
the left side of the rear handle and then the operating
switch (10).
• The stopping button (9) is used for unlocking the
switch-on mechanism and does not need to be
pressed again after the device is switched on.
• To switch off the device, release switch (10).
Note: The sparks (flashes) developing from this in the
area of the upper ventilation slots are normal and harm-
less for the device.
The model is with an additional „Power-switch" (15)
feature. This can vary the output in 2 steps. High (II) =
higher performance, low (I) = reduced performance. In
the position „low" will increase the battery time to about
twice the duration, while the speed of the hedge trimmer
is lowered. You can use this setting for lighter work to
increase the battery life.
GB-10
9
10