Maintenance And Cleaning; Declaration Of Conformity (Doc) - Renkforce 1377592 Bedienungsanleitung

Problem
One hand microphone is
not received.
Audio playback is
intermittent.
Noise / signal distortion

14. Maintenance and cleaning

Never use aggressive and abrasive detergents, rubbing alcohol or other chemical solutions,
as these could damage the housing or even impair the functioning of the product.
• Regularly check the product for damage, e.g. for damage to the housing.
• Disconnect the product from the power supply before cleaning.
• Do not immerse the product in water.
• The product should only be cleaned with a soft, dry cloth or brush.

15. Declaration of conformity (DOC)

We, Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this product
conforms to the fundamental requirements and the other relevant regulations of the directive 1999/5/EC.
The Declaration of Conformity for this product can be found at www.conrad.com.
28
Possible cause
The batteries on the transmitters (hand
microphones) are empty.
There are distortions during signal
transmission, or there is no reception.
The antennas have not been set to the
optimum position.
There are obstacles impairing
transmission (e.g. metal surfaces,
reinforced concrete walls).
The range of the system is exceeded.
There are sources of interference near
the transmitter or receiver (radios,
computers, strong electric motors etc.).
A dead spot is impairing transmission.
Another radio appliance is interfering
with the transmission.
Possible solution
Change the batteries.
Try repositioning the antennas.
Change the position of the
transmitter and receiver, or
place them closer together.
Avoid dead spots when using
the hand microphone.
Avoid using other devices on the
same frequency band as one or
both of the transmitters.