D) Selecting Thermo/Hygro Sensor; E) Maximum/Minimum Values; F) Switching The Temperature Unit - Eurochron EWM001 Bedienungsanleitung

d) Selecting Thermo/Hygro Sensor

Briefly push the "IN/CH" button repeatedly to switch between the following displays:
• "OUT CH1": Displays the data measured by the thermo/hygro sensor on transmission channel 1
• "OUT CH2": Displays the data measured by the thermo/hygro sensor on transmission channel 2
• "OUT CH3": Displays the data measured by the thermo/hygro sensor on transmission channel 3
• "IN": Displays the measured data of the sensors in the basis station
• " ": All channels/measured data are automatically displayed in sequence
The basis station can be operated with up to three thermo/hygro sensors, one is enclosed; up to two more
can be ordered as accessories.
If measured data are not available, the display will show dashes.

e) Maximum/Minimum Values

Displaying the Maximum/Minimum Values
Briefly push the "MAX/MIN" (8) button repeatedly to switch between the following displays:
• Maximum values ("MAX" appears in the display)
• Minimum values ("MIN" appears in the display)
• Current measured values
If the maximum or minimum values are displayed and you do not push any button, the display will automati-
cally switch back to the current measured values after a few seconds.
Resetting/deleting the maximum/minimum values
• Briefly push the Taste "MAX/MIN" (8) to display the maximum values ("MAX") or the minimum values ("MIN").
• Keep the "MAX/MIN" (8) button pushed for 2 - 3 seconds until a sound signal is issued. Then all saved maximum
and minimum values are deleted (temperature, humidity, wind speed).

f) Switching the Temperature Unit

Briefly push the "+/°C/°F" (6) button repeatedly to switch between the temperature unit °C (degrees Celsius) and °F
(degrees Fahrenheit).
If the maximum or minimum values are displayed and you do not push any button, the display will automati-
cally switch back to the current measured values after a few seconds.
44