Power Switch; Battery Compartment - Omnitronic WHP-800 Bedienungsanleitung

9. POWER SWITCH

Set this switch to ON to start operating.
10. POWER LED
This LED lights red, when you power on the receiver via the POWER switch. As soon as the headphones
receive an audio signal, the LED lights orange. When the battery is going flat, the LED starts blinking and the
device shuts off automatically within a few minutes.
11. FREQUENCY SELECTION RECEIVER
This button adjusts the frequency of the receiver. Press this button to increase the frequency or keep the
button pressed for a few seconds to enter Auto Scan mode. If reception is subject to interference, change
the transmission channel. To do so, set the frequency via buttons M and N of the transmitter to another
position and re-adjust the receiver.
12. CHARGING SHAFT
For charging, insert the headphones' charging shafts on the charging ports of the transmitter.
13. VOLUME
On the receiver, the volume can be adjusted between steps 0 and 10.

14. BATTERY COMPARTMENT

Remove the cover to replace discharged batteries.
16/20 00026592.DOC