Noise/Vibration Information; Mounting And Operation - Bosch ART 23 SL Originalbetriebsanleitung

OBJ_BUCH-2058-004.book Page 13 Wednesday, August 9, 2017 11:28 AM

Noise/Vibration Information

Sound emission values determined according to EN 50636-2-91.
Typically the A-weighted noise levels of the product are:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K deter-
h
mined according to EN 50636-2-91:
Vibration emission value a
h
Uncertainty K

Mounting and Operation

 Do not disassemble guard and metal tube once con-
nected.
 Do not connect the machine to the mains socket before
it is completely assembled.
 The cutting line continues to rotate for a few seconds
after the trimmer is switched off. Allow the motor/cut-
ting line to stop rotating before switching "on" again.
 Do not rapidly switch off and on.
 Remove any grass from spool cover when changing line
or spool.
 Only use Bosch approved cutting elements. Cutting
performance will vary with different cutting elements.
Check the guard screw is fixed tightly before using.
Check the tube joint is on correct position before using.
The machine will automatically feed and cut the line when the
tool starts and stops.
Troubleshooting
Problem
Trimmer fails to operate
Trimmer runs intermittently
Trimmer motor is stalling
Trimmer does not cut
Bosch Power Tools
Action
Delivery Scope
Removing the Rubber Stop
Connecting the Tube
Mounting the Cutting Guard
Connecting the extension lead
Switching On and Off
Semi-auto feeding of 8 mm cutting
line when starting the tool
Removing the line spool
Mounting the line spool
Feed cutting line using manual feed
button
Maintenance, Cleaning and Storage
Selecting Accessories
Possible Cause
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Extension cable damaged
Internal wiring of machine dam-
aged
Grass too high
Cutting line too short/broken off
Spool empty
3 600 ... HA5 0.. HA5 1..
dB(A) 84 86
dB(A) 91 92
dB =2 =2
2
m/s <2.5 <2.5
2
m/s =1.5 =1.5
Corrective Action
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Inspect cable, replace if damaged
Contact Service Agent
Contact Service Agent
Cut in stages
Feed cutting line using manual feed button (see
figure 9)
Replace the spool
F 016 L81 728 | (9.8.17)
English | 13
HA5 0.. HA5 0..
84 84
91 91
=2 =2
<2.5 <2.5
=1.5 =1.5
Figure Page
1 198
2 198
3 199
4 199
5 200
6 200
7 201
8 201
9 202
10 202
11 203