Functional Overview; Base Station (Front Panel) - Philips SBC HD1500U Bedienungsanleitung

Functional Overview

Base station (front panel)

1 STANDBY – ON
By holding the STANDBY-ON button for 1.5 seconds or longer, the demo
mode can be activated.
• Pink noise is used to simulate the position of the 5 virtual speakers in the
headphone
• The corresponding speaker indicator on the display panel will go on
indicating which speaker is being simulated.
• The demo mode can be deactivated by pressing any control button on
the base station.
Mode indication
– Red = Base station in standby mode
– Green = Base station in active mode
2 SOURCE
• Yellow indication
• Push the SOURCE button to select signal source: ANALOG 1,
ANALOG 2, DIGITAL 1 (P/SDIF), DIGITAL 2 (Optical Digital)
ANALOG 1 / ANALOG 2
• When analog sources being selected, the green indicator light is on.
DIGITAL 1/ DIGITAL 2
– Red = no signal received, or invalid signal detected (for recognizable
digital format, please refer to Important Information section)
– Green = valid signal detected
CHARGE indicator
– Red = low-rate charging + in progress
– Green = trickle charging ++ in progress
– Off = battery compartment empty
+ This charging process will result in an increased lifespan of the batteries.
++ When the batteries are fully charged, the charging circuitry switches to
'trickle charging' in order to keep the batteries in fully charged
condition, but without overcharging it.
STEREO indicator
– an analog source is selected, OR
– a digital stereo signal source is detected
ENGLISH 19