Ideen Welt P8-RM-SBC Bedienungsanleitung Seite 23

RISK OF BURNING! The appliance becomes very hot.
Take care when touching the appliance and only touch
the glass jug
plate
sufficient time for the appliance to cool down before
cleaning the appliance.
RISK OF BURNING! Only pour liquids out of the glass
jug ⑦
RISK OF INJURY AND ELECTRIC SHOCK! Do not fill the
appliance above the "MAX" mark on the water
gauge
of the water tank
RISK OF FIRE! Never operate the coffee machine unless
it has been filled with water up to at least the "MIN"
mark on the water gauge
Only move the appliance when it is switched off, after
the heating plate
down and only when you have removed the glass jug
from the heating plate
RISK OF INJURY AND RISK OF DAMAGE TO HEALTH!
Only fill the appliance with fresh drinking water. Never
use water that has not been designated safe to drink.
1. Remove the glass jug
water. Observe the minimum and maximum levels!
①
2. Open the lid by pulling it upwards at the opening aid.
3. Do not fill the water tank
4. Remove the permanent filter
no. 4) into the filter holder
5. Fill the inserted filter with the desired amount of coffee. We recommend using the supplied
measuring spoon
coffee depending on the desired strength of the coffee.
①
6. Close the lid .
7. Plug the mains plug into an appropriate mains socket. Check that the mains voltage and the type of
electrical current matches the information provided on the type plate on the appliance before
connecting it to the mains power supply.
8. Place the glass jug
the heating plate
9. Start the brewing process by pressing the ON/OFF button
10. Allow the appliance to fully complete the brewing process. Wait a moment after the pumping sounds
stop until the water has had enough time to also pass through the ground filter coffee powder and
the filter.
11. The coffee is ready to enjoy. Remove the glass jug
⑦ at the handle. Never touch the heating
⑧ during or immediately after operation. Allow
using the spout provided for this purpose.
⑤ . Otherwise, the excess water could splash out
②
⑧
⑦
from the heating plate
②
above the MAX mark on the water gauge
④
if you do not want to use it. Insert a single-use paper filter (size
③
.
⑩
and adding a level spoon for each cup. You can use more or less ground filter
⑦
back in the correct position between the drip stop on the filter holder
⑧
.
via the water overflow
⑤ .
has had sufficient time to cool
⑧ .
⑧
to fill it with the desired amount of drinking
⑨
to switch on the appliance.
⑦
from the heating plate
G
⑪ .
⑤
.
.
⑦
③
and