Note On Environmental Protection - Hama 00136682 Bedienungsanleitung

Warning
Connect this earthing point to the vehicle earth as
far away from thebattery as possible to avoid igniting
explosive gas which may be present.
5.3 Starting
• Start the engine of the good vehicle and run at a medium
engine speed.
• Start the engine of the vehicle with the drained battery
• (starting attempt max. 15 seconds - wait at least one
minute between additional attempts to start).
• After successfully starting the vehicle engine with the
drained battery wait 2 to 3 minutes until it runs smoothly.
5.4 Disconnecting
Note
Before disconnecting the jumper leads the rear and front
defrost should be switched on in the vehicle with the
drained battery (do not switch on vehicle lights). This
will reduce possible voltage spikes whilst disconnecting
and prevent damaging electrical parts.
red
Disconnect the terminal damps in the following order:
Warning
When disconnecting the jumper cables, be careful they
do not come into contact with the moving parts of the
engine.
1. Negative lead (black) from earth point of vehicle with
drained battery.
2. Negative lead (black) from negative terminal of good
battery.
3. Positive leads (red) in any order.
After jumpstarting drive the broken-down vehicle for
a longer distance to charge the battery. You may also
recharge the battery with a charger.
black
6. First aid
In the event of contact with battery acid immediately wash
or flush the affected areas under running water. Seek
immediate medical attention for chemical burns of the eye
or mucous membranes
7. Care and Maintenance
Always maintain clean leads and check jumper leads for
damage prior to each use. Do not use damaged jumper
leads (e.g. frayed lead broken or welded terminal clamps).
Please contact your retailer or a qualified professional for
damages repairs or other product issues.
8. Technical Data
The jumper leads meet the requirements of DIN 72553
and are suitable for wiring system voltages from of 12 and
24 V.
The leads consist of insulated copper-clad aluminium
wires with fully insulated terminal damps.
9. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
10. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
11. Recycling Information

Note on environmental protection:

After the implementation of the European Directive
2012/19/EU and 2006/66/EU in the national legal
system, the following applies: Electric and
electronic devices as well as batteries must not be
disposed of with household waste. Consumers are obliged
by law to return electrical and electronic devices as well as
batteries at the end of their service lives to the public
collecting points set up for this purpose or point of sale.
Details to this are defined by the national law of the
respective country. This symbol on the product, the
instruction manual or the package indicates that a product
is subject to these regulations. By recycling, reusing the
materials or other forms of utilising old devices/batteries,
you are making an important contribution to protecting our
environment.
3