Bellman & Symfon BE2210 Bedienungsanleitung Seite 19

Transmitter Unit
• Switch on the unit and make sure that the Battery Status LED (17) lights up
green.
•
Press the R button (7) and make sure that the External Sound LED (4) lights up
green.
• Carefully scrape on the round microphone hole (16) on the top of the Transmit-
ter Unit with the finger and check that there is a scraping sound in the head-
phones.
• Press the R button (7) and make sure that the External Sound LED (4) changes
colour and lights up orange.
• Carefully scrape on the round microphone (16) on the Transmitter Unit with the
finger and check that there is a scraping sound in the headphones.
• Connect an external sound source to the External Sound Source Input (20) and
check that the sound from the sound source is heard in the headphones. The
external sound source input (20) can be tested, for example, by connecting a CD
player or a radio to the input via the audio cable supplied. The transmitter unit
automatically switches to an external sound source when a connector is con-
nected to the External Sound Source Input (20).
324
Charging
• Connect the charger to the mains socket and check that the LED on the charger
light up green.
•
Connect the charging cables to both the charger and to the charging sockets on
the Receiver Unit and the Transmitter Unit (14, 21), see the fold-out section of the
manual.
• Check that the LED on the charger change from green to red.
• Check that the Battery Status LEDs on both the Transmitter Unit and Receiver
Unit light up orange.
APP
325