Schego TRD Bedienungsanleitung Seite 17

Faults
Before complaining about damage to the thermostat, check this table to see if you can
remedy the fault yourself.
Fault
Heat source will not heat.
Heat source heats
permanently
Display is not lit
Cause
Target temperature is set
too low
The current temperature
is measured incorrectly
Sensor or sensor cable
defective
Thermostat defective
Target temperature is set
too high.
Sensor or sensor cable
defective
The building's power
supply has been
interrupted
Thermostat defective
Remedy
Increase the target
temperature.
Ensure that the sensor is not
placed too close to the heat
source and is not exposed to
direct sunlight.
Ensure that the sensor is
positioned so that it correctly
measures the temperature of
the medium.
Replace the thermostat.
Replace the thermostat.
Reduce the target
temperature.
Replace the thermostat.
Check the building's power
supply.
Replace the thermostat.
Faults
17