Automatic Address Allocation With Data Carrier; Manual Address Allocation Via Reader Keypad - Honeywell mifare-Leser "Accentic" Anleitung

Mounting and Connection Instructions mifare/DESFire EV1 reader "Accentic" with/without keypad
26
6.2.5

Automatic address allocation with data carrier

The address allocation mode must be activated.
Hold an mifare data carrier in the reading range. The reader now transmits the serial number to the
controller. The controller allocates a free address to this number and transmits the serial number
plus the address back to the reader. After a brief interval, the reader stores the address
permanently.
Address acknowledgement: After approx. 1 sec. the LEDs indicate the allocated address (see
6.2.3).
ACS-8
IK3
DCM
allocates a free
address to the
serial number
6.2.6

Manual address allocation via reader keypad

The address allocation mode must be activated.
When using this allocation mode, a specific address can be allocated to an
reader on site. The plausibility check in the controller prevents an address
from being allocated more than once.
Note:
- Every activated key is acknowledged by a click.
- An address entry can be rejected by an X.
Enter the new address with 1 or 2 digits and acknowledge with OK (key
The address is transmitted to the controller and checked.
Positive acknowledgement
After remaining blank for approx. 1 sec. the LEDs indicate the newly
allocated address (see 6.2.3).
Negative acknowledgement
If the address is already occupied, it is not allocated to the reader and there is no address indicated.
Change address
Enter new address with 1 or 2 digits and acknowledge with OK. (Acknowledgement and indication as
described above). All allocated parameters are transmitted from the old address to the new one so that
the old address can be re-allocated.
Serial number
Serial number
+ address
1 2
5
4
7 8
r
0
3
).
Delete Confirmation
Reject OK
3
6
9
3