Inhaltsverzeichnis
Werbung
Ringer
1. Lift the receiver (ignore the dialling tone) and press the store button p and
2. Select ring signal by pressing the number keys
3. Press store button p and replace the receiver. The ring signal is now set.
Melody type
Melody A . ...................... 1=Low, 2=Normal, 3=High
Melody B . ...................... 4=Low, 5=Normal, 6=High
Melody C . ...................... 7=Low, 8=Normal, 9=High
Off*................................ 0
* If the key 0 is selected, the ring signal will be turned off until the next time the receiver is lifted. After
that, the ring signal will revert to the previous setting.
Technical information
Some selector switches are located in a compartment on the underside of the telephone.
These switches control technical parameters for connection to PBX equipment.
IMPORTANT NOTE:
These switches should only be adjusted by qualified personnel.
Recall time
Selection of 100/300/600ms timed loop break for recall functionality.
The standard setting is 100 ms for UK/Australia and 600 ms for New Zealand.
EARTH/TIME (UK only)
Selection of either earth or timed loop break recall method.
Tone/Pulse
Selection of either dialling method depending on PBX.
Message Waiting Indicator
Some PBX systems have a function called Message Waiting.
The switch is located behind the battery cover on the underside of the telephone.
The MW function operates differently depending on the PBX in question. The
following four alternatives are available: +, -, ringer indicator (
voltage (HV).
English
Key/level
-
in accordance with the table below.
0
9
) and high DC
.
#
Werbung
Inhaltsverzeichnis
Fehlerbehebung
