Connection And Operating Elements - Conrad Electronic Mc Crypt Mini Mixer DJ 1/2 Bedienungsanleitung

Connection and Operating Elements

See image on the fold-out page.
(1) ON/OFF switch (POWER)
Turn the mixing desk on and off with this switch. The appliance is turned on when the
switch is in the "ON" position. When the appliance is turned on, the first LEDs of the
recording level indicator (9) light up.
The power pack still consumes small amounts of energy when the on/off switch is in
the position "OFF". In order to completely separate the appliance from the electricity
net, you have to pull the power pack out of the outlet.
(2) Headphone volume controller (CUE LEVEL)
With this controller, you adjust the volume of the connected headphones. Position
"0" is the minimum, position "10" the maximum headphone volume.
(3) Gain controller (GAIN)
With this controller, you adjust the input level of the signals. Position "0" is the mini-
mum, position "10" the maximum volume.
The controller GAIN "CH1" controls channel 1 (phono and line), controller GAIN
"CH2" channel 2 (phono and line).
(4) Stereo fader
With these controllers, you set the output levels of channels 1 and 2. Position "10" is
the maximum volume. The controller "CH1" controls channel 1 (phono and line), con-
troller "CH2" channel 2 (phono and line).
(5) Headphone socket
You can plug stereo headphones with a minimum impedance of 8 Ohm into this 6.3
mm socket for pre-listening.
(6) "TALK OVER" switch
With this switch, you can attenuate the signal of the LINE and PHONO inputs when
making announcements over the microphone.
When set to "ON", the volume of the output signal is attenuated.
(7) Microphone input controller
This controller sets the microphone level.
In position "0", the microphone volume is at its minimum, in position "10" at its max-
imum.
26
Symptom Possible cause
No signal to be heard The subsequent appliance Check the subsequent
although the recording is not turned on or
level indicator shows a adjusted wrongly.
signal.
Output wrong or not
connected.
In/output level is adjusted
wrongly.
The sound is too low. The talk over switch (6)
is on.
Fader/gain slider is
wrongly adjusted.
There is a humming A cable is defect.
sound.
There is a humming loop
between the connected
appliances.
A cable has become
One channel does
lose.
not work.
Error remedy
appliance and select the
right input on the
amplifier.
Connect the output as
described.
Adjust the in/output level
as described.
Only use the talk over
switch when you want
to make an announcement
with the microphone.
Adjust the fader/gain
slider correctly.
Exchange the cable.
Connect the signal
ground with a specially
ground-insulated cable.
Attention! Do not
interrupt the protective
earth connection of the
voltage supply!
Check the connections
between the
appliances.
35