Continuous Mode - AIPTEK Pencam Compact Handbuch

ENGLISH
Self Timer
Pressing the mode button until "St" appears in the
LCD then pressing the shutter button will start a 10
second self-timer. The camera will issue a short
beep every second and then a longer beep. The
next beep indicates that the picture has been taken.
Note: The self-timer can not be selected when the
camera is full.

Continuous mode

Pictures may be taken continuously as long as the
shutter button is pressed(and the camera is not full)
as follows:
Press the mode button until the Ct appears in the
LCD. Pressing the shutter button within 5 seconds
will cause the camera to start taking pictures for as
long as the shutter button is held down. If the shutter
button is not pressed within 5 seconds the camera
will revert back to normal picture taking. Note:
During the continuous mode the camera will allow
pictures to be taken with incorrect exposure.
Clearing the stored images
Press the mode button until CL appears on the
LCD. Pressing the shutter button once will cause
the camera to beep and the CL will start flashing .
Pressing the shutter button again within 5 seconds
will clear the camera and reset the picture counter.
Changing the picture resolution
Picture resolution may only be changed when the
camera memory is empty. If any pictures have
been taken then the memory must first be cleared.
To change resolution press the mode switch until
the resolution option is displayed, either Hr to
change to high resolution mode (if you are currently
in the low resolution mode)or Lr to change to low
resolution(if you are currently in the high resolution
mode). The camera will beep and the display will
reset to indicate the number of pictures available.
Switch mode to "St"
"St" will be displayed
Press SW1 to initiate
the self-timer mode
Switch mode to "Hr" or "Lr"
"Hr" or "Lr" will be displayed
Press SW1 to change resolution
My digital eye!
Switch mode to "Ct"
"Ct" will be displayed
Press SW1 to utilize
Continuous mode
Switch mode to "CL"
"CL" will be displayed
Press SW1 to
select clear mode
LCD will start flashing
Click SW1 twice to clear
the memory