Changing System Settings - Clatronic dvb t 774 Bedienungsanleitung

CL_BDA_DVB_T774_GB_ka2.qxd

Changing system settings

Attention!
Select only the option "on" with "active antenna",
if you connect an active DVB-T antenna.
Otherwise, the receiver or antenna may be dama-
ged.
Setting
OSD
Time on OSD
OSD Time out
OSD Trans
OSD Language
MP4 subtitles language
1st Audio language
2nd Audio language
Display mode
Aspect ratio
Video output
Brightness, contrast,
hue, saturation
EQ Setup
Surround
active antenna
JPEG effect
LCN
Area
Timer Mode
Wake up Timer
Parental Lock
Carry out the desired settings.
08.01.2008 17:26 Uhr
Options Explanation
Theme 1-5 You can select the OSD menu background colour.
OFF/ON You can select whether time is to be permanently displayed.
1-6 Select the time after which the OSD is to fade out.
0%-60% Select the transparency of the OSD menu.
You can select the required language for the screen menu.
Here you can select the preferred subtitle language for MPEG4 files.
You can select the first and second audio language.
auto/ If you are not sure which TV standard
PAL/NTSC is suitable, select "Auto".
4:3 LB/4:3PS/16:9 Select between 4:3 format or 16:9 format (wide screen) according
to your screen.
4:3 LB: transmissions in wide screen format are fully displayed. You
will see black margins on the top and the bottom of the screen.
4:3 PS: Transmissions in wide screen format are altered in such a way
that the most important part of the picture is always in the centre of a
4:3 picture.
16:9: Select the 16:9 format with a wide screen TV.
RGB/CVBS Select the suitable video signal (RGB or CVBS).
Adjust brightness, contrast, hue and saturation
Standard/classic/ You can select the required sound option.
Rock/Jazz/POP
off/concert/ this function creates different acoustics for a specific surrounding,
church/passive/live e.g. at a concert or in a church.
off/on when "off", no voltage is connected to the antenna output – suitable
for connection to the roof antenna and the passive DVB-T antenna.
When "on" an active DVB-T antenna without its own power supply can
be connected.
off/on You can select whether in the photo mode each picture is faded in with
each picture change.
off/on If supported by TV channels, with the LCN function switched on,
your regional channels are saved sorted, independent from their frequency.
If the LCN function is activated the programme slot numbers are also moved.
Select your country.
Here, you can set the time of the receiver
(see‚ Change time settings' section).
Here, you can programme the timer or change/delete existing programmes.
Change/delete programming
Here, you can change the pin code of the receiver. The code preset by the
factory is '0000'.
Seite 37
Select the "Configuration" menu.
You can carry out the following settings in the sub-
menus:
37