Removing; Cleaning; Rectifying Malfunctions - Clatronic dvb t 774 Bedienungsanleitung

CL_BDA_DVB_T774_GB_ka2.qxd
This function can only be used if the station
which is set offers teletext.
In order to exit the teletext, press the "EXIT" but-
ton.
Selecting an audio setting
This setting can be used to switch between stereo,
and (mono) left or (mono) right.
In order to change audio settings, press the
"LANGUAGE L/R" button during operation.
Press the "
ting is displayed.
Press the "EXIT" button, in order to return to the
normal screen display.
Recall
To call up the channel which was last selected
again, press the "RECALL" key.

Removing

Disconnect the receiver and the connected devi-
ces from the power supply.
Disconnect the antenna cable from the receiver.

Rectifying malfunctions

Symptom
The view in the display
does not light up.
No sound and no picture, The receiver is in standby mode.
the time display at the
receiver is lighted.
No sound or picture.
The TV set does
not show a picture.
Poor picture,
locking error
The remote control
does not function.
If a malfunction still cannot be rectified, please contact your specialist dealer.
44
08.01.2008
VOL+" button until the required set-
Possible cause and remedy
The power cable is not connected.
Connect the power cable to the mains socket.
The mains switch is not switched on.
Switch the mains switch on.
Press the "Power" key. The receiver switches on and the
channel is shown on the TV screen.
No signal or a weak signal only.
Check the cable connection to the receiver and from the receiver to the
connected devices.
Align the antenna.
The system is not connected correctly.
Check the SCART or HF cable's connection.
The TV set is not in AV mode.
Switch the TV set to the relevant AV input.
The antenna is not aligned correctly.
Align the antenna.
The batteries are spent.
Replace the batteries with new ones.
The remote control is not being pointed properly.
Point the remote control at the front of the receiver and make sure that nothing
is positioned between the remote control and the receiver.
17:26 Uhr Seite 44
Remove the batteries from the remote control if
you do not use the receiver for a long period of
time.
Package the receiver, the cables and the remote
control in the original packaging.
Store the receiver and all accessories in a dry
and dust-free location.
Protect the receiver from frost.

Cleaning

Risk of electric shock!
No fluid must enter the receiver. Never clean it
with a wet cloth.
Prior to cleaning, remove the mains plug from the
mains socket.
Attention!
Do not use cleaning agents which contain sol-
vents, such as benzene or thinner. These agents
may damage the surface of the housing.
Clean the receiver's housing using a dry cloth.