Before Starting (Initial Settings) - Samsung BD-C5900 Bedienungsanleitung

Setup

Before Starting (Initial Settings)

1.
Turn on your TV after connecting the product.
(When the product is connected to TV for the
first time, product will turn on automatically and
the Initial Settings screen will be displayed.)
Initial Settings I On-Screen Language
Select a language for the on-screen displays.
English
Français
Deutsch
Español
Italiano
Nederlands
2.
Press the ▲▼ buttons to select desired
language, then press the ENTER button.
3. Press the ENTER button to select Start
button.
Initial Settings
TV Aspect and Network will be set.
Each setting may be changed later under "Settings"
4.
Press the ▲▼ buttons to select the desired
TV Aspect ratio, then press the ENTER
button. (See page 31)
Initial Settings I Network
Network Setting is needed to use various Internet services.
Choose the primary method for connecting to network.
Wired : Set the network connection using the Ethernet cable.
Please make sure that the Ethernet cable is connected.
Wired

English
01963E-BD-C5900-XEN-ENG.indb 28
> Move " Select
Start
Previous " Select
a
Wireless PBC (WPS)
Previous Skip < Move " Select
a d
5.
Press the ◄► buttons to the select the
desired Network Settings: Wired, Wireless or
PBC (WPS), then press the ENTER button.
(See pages 37~40)
The Network Test will start and Initial Settings
will be completed.
6. Press the OK button.
The home menu will be displayed. (For more
information about home menu, please see
page 29)
Home Menu
•
Please activate Internet@TV service
internet radio
to enjoy a variety of Internet Services.
No Disc a Change Device
NOTE
▪
When the product is connected to TV for the first
time, product will turn on automatically.
Do not confuse because this is not malfunction.
▪
The home menu will not be displayed if you do not
configure the initial settings.
If you press the BLUE(D) button during the network
▪
setup, you can access the home menu even if the
network setup is not completed yet.
▪
When you return to home menu, the full screen
mode will be cancelled automatically.
▪ If you want to display Initial Setting screen again
in order to make changes, press the STOP (
button on the front panel of the product for more
than 5 seconds with no disc inserted.
▪ Use the HDMI cable to connect the product to an
Anynet+(HDMI-CEC)-compliant Samsung TV.
If the TV uses a language supported by the product,
that language will be set to a preferred language
automatically.
However, the Anynet+(HDMI-CEC) feature should
be set to On in both TV and the product.
You Tube
d View Devices " Enter
)
2010-11-05 오후 2:28:07