Yamaha TX-492 Bedienungsanleitung Seite 6

CONNECTIONS TO THE AMPLIFIER
Before making any connections, switch OFF the power to
this unit and the amplifier or other component.
Be sure that the connections from the left ("L") and right
("R") LINE OUT terminals are connected to the
corresponding (left and right) input terminals of the amplifier
or other component.
FM ANT GND AM ANT
75Ω UNBAL.
NOTES ABOUT CONTROLLING THIS UNIT WITH THE REMOTE CONTROL
TRANSMITTER
This unit has a remote control sensor. It receives signals from
a remote control transmitter provided with a YAMAHA amplifier
or receiver.
* Parts in shaded area
( ) are present on
TX-492RDS only.
6
Remote control
sensor
Within approximately
6 m (19.7 feet)
If you have a YAMAHA amplifier whose terminals on the
rear panel are numbered as 1, 2, 3, etc., connections can
be made easily by making sure to connect the LINE OUT
terminals of this unit to the input terminals of the amplifier
numbered 2.
TUNER
Connection cord (included)
This unit (Europe model)
LINE OUT
R L
2
Notes
There should be no large obstacles between the remote
control transmitter and the main unit.
If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid
direct lighting.
L
R
Amplifier
l6
20 l2
28 8
4
40
60 2
0
–dB
To AC outlet