Programmed Playback - JVC RC-EX25S Bedienungsanleitung

Programmed playback

Up to 20 tracks can be programmed to play in any desired order.
Note:
There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
1 Press CD/RANDOM to enter CD mode.
You can press CD/RANDOM on the remote control
unit to enter CD mode.
2 Press PROGRAM/CLOCK SET in stop mode.
The PROG indicator starts blinking in the display
window.
CD
PROG
3 Press 4 or ¢ to select a desired track to be
programmed.
CD
PROG
Track to be programmed
4 Press PROGRAM/CLOCK SET.
5 Repeat steps 3 and 4 to program other tracks.
6 Press PLAY/PAUSE 3 /8 while the PROG
indicator blinks.
The tracks are played in the order you have
programmed.
You can press CD PLAY/PAUSE on the remote
control unit to start programmed playback.
Notes:
• If the PROG indicator goes off before you press PLAY/
PAUSE 3/8 (or CD PLAY/PAUSE on the remote
control unit), press PROGRAM/CLOCK SET, then
start playback.
• If you press CD/RANDOM while in CD mode, the unit
enters the random playback mode.
1 3,5
PUSH
REMOTE
DISPLAY
SENSOR
2,4,5 6
To stop during playback
Press STOP 7 (or STOP on the remote control unit).
The PROG indicator goes off and the unit exits from
programmed playback.
To check the program contents
Before starting programmed playback, press
PROGRAM/CLOCK SET.
Each time you press the button, the programmed tracks
are shown in the display window.
To add tracks in the program
1 Press PROGRAM/CLOCK SET repeatedly so that
"00" appears as the track number.
2 Press 4 or ¢ to select the track number, then
press PROGRAM/CLOCK SET.
To edit the program
1 Press PROGRAM/CLOCK SET repeatedly so that
the program number you want to edit is shown.
2 Press 4 or ¢ to select a new track number,
then press PROGRAM/CLOCK SET.
To repeat programmed playback
Press PRESET + / CD REPEAT (or CD REPEAT /
PRESET + on the remote control unit) after starting
programmed playback.
To erase the entire program in the memory
Press PROGRAM/CLOCK SET so that the PROG
indicator blinks, and press STOP 7 (or STOP on the
remote control unit) while the PROG indicator blinks.
The stored program is also cleared when the disc door is
opened.
Note:
After you have programmed 20 tracks, the program
number returns to "1." Programming more tracks
overwrite the tracks already programmed to those
numbers.
1 3 6
STANDBY/ON DISPLAY
CD/ TUNER/
RANDOM BAND TAPE
CD PLAY
INTRO STOP /PAUSE
FM MODE
HBS/
CD REPEAT/ +
+ PRESET EQ
PRESET MUTING VOLUME
– –
RM-SRCEX25A REMOTE CONTROL
12