Alde 3010 213 Installationsanleitung Seite 15

7. Heating with gas
Do as follows to activate heating with gas.
1. Press the button with the arrow
until the gas heating symbol
flashes. The "OFF" text is shown
next to the temperature on the
display.
flashes blinkar
Do as follows to switch off the gas heating.
1. Press the button with the arrow
until the gas heating symbol
flashes. The "ON" text is shown
next to the temperature on the
display.
flashes
blinkar
8. Heating with electricity
To activate heating with electricity. The greater the power the more rapid the heating will be.
1. Press the button with the arrow
until the electrical heating sym-
bol flashes. The "OFF" text is
shown next to the temperature
on the display.
blinkar flashes
Do as follows to switch off heating with electricity.
1. Press the button with the arrow
until the electrical heating sym-
bol flashes.
flashes
blinkar
9. Circulation pump
This symbol is displayed when the circulation pump is operating (12V-pump or
230V-pump). When heat is needed, the pump starts automatically.
The boiler selects the 230V pump if one is installed in the system. When the
230V is disconnected from the vehicle the 12V pump is automatically selected.
The symbol will light up even if the pump is defective.
2. Select gas heating by pressing
the +/On button. The "ON" text
is shown next to the tempera-
ture on the display.
flashes
blinkar
2. Switch off the gas heating by
pressing the -/Off button. The
"OFF" text is shown next to the
temperature on the display.
flashes
blinkar
2. Select power (1kW, 2kW or
3kW) with the +/On or -/Off but-
tons. The diagram shows that
3kW power has been selected
(some boilers are only equipped
with 1-2kW).
flashes blinkar
2. Switch off the electrical heating
by pressing the -/Off button until
all power steps have gone out.
The "OFF" text is shown next to
the temperature on the display.
3. The gas heating symbol is dis-
played when the panel returns
to standby.
3. The gas heating symbol goes
out when the panel returns to
standby.
3. The electrical heating symbol is
shown when the panel returns to
standby.
3. The electrical heating symbol
goes out when the panel returns
to standby.
15