Preparation For Use; Setting The Alarm Time - iCES ICR-240 Bedienungsanleitung

PREPARATION FOR USE

This clock radio includes a battery backup system that will maintain the time and
alarm settings during a temporary power interruption. Insert two 'AAA' size batteries
correctly by matching the polarity (+/-) markings in the battery compartment (10). If
you experience a power failure while batteries are installed, the display will turn 'off'
but the clock will continue to run and maintain your alarm settings. Please replace all
batteries at the same time with only new batteries.
The clock radio has slip proof silicon feet. Place the clock radio only on protected
furniture.
Plug AC plug (12) into 230vac electrical outlet.
Unwind the FM antenna (11) on the back of the clock radio. Extend and reposition
the antenna for best radio reception.
ALARM CLOCK OPERATION
SETTING THE TIME
Note:
 You cannot set any function when the clock display is blinking after plug in, press
the "TIME/PRESET" to stop blink and start setting.
 The time can only be set when the radio is turned off. Press the "ON / OFF / NAP"
button (2) to turn radio on or off.
 When the clock display is blinking, you cannot power on radio by the "ON / OFF /
NAP" button (2).
1. Press and hold down "TIME / PRESET" button (6) for approximately 3 seconds
until the display flashes.
2. Press "HOUR / TUNING –" button (5) repeatedly to change the hour setting.
3. Press "MIN / TUNING +" button (9) repeatedly to change the minute setting.
4. Press "TIME / PRESET" button (6) to confirm at the time and the display will stop
flashing.

SETTING THE ALARM TIME

This clock radio has dual alarms that can be set and used independently. The
procedure to set both alarms are the same. Both alarms can either sound the buzzer
or wake up to radio.
Note: The alarm time can only be set when the radio is turned off. Press the "ON /