Preparation For Use; Setting The Alarm Time - iCES ICR-240 Bedienungsanleitung

PREPARATION FOR USE

This clock radio includes a battery backup system that will maintain the time and
alarm settings during a temporary power interruption. I sert two AAA size atteries
correctly by matching the polarity (+/-) markings in the battery compartment (10). If
you experience a power failure while batteries are i stalled, the displa will tur off
but the clock will continue to run and maintain your alarm settings. Please replace all
batteries at the same time with only new batteries.
The clock radio has slip proof silicon feet. Place the clock radio only on protected
furniture.
Plug AC plug (12) into 230vac electrical outlet.
Unwind the FM antenna (11) on the back of the clock radio. Extend and reposition
the antenna for best radio reception.
ALARM CLOCK OPERATION
SETTING THE TIME
Note:
 You cannot set any function when the clock display is blinking after plug in, press
the TIME/PRESET to stop blink and start setting.
 The time can only be set when the radio is turned off. Press the ON / OFF / NAP
button (2) to turn radio on or off.
 When the clock display is blinking, you cannot power on radio by the ON / OFF /
NAP utto
1. Press a d hold dow
until the display flashes.
2. Press HOUR / TUNING –
3. Press MIN / TUNING +
4. Press TIME / PRESET
flashing.

SETTING THE ALARM TIME

This clock radio has dual alarms that can be set and used independently. The
procedure to set both alarms are the same. Both alarms can either sound the buzzer
or wake up to radio.
Note: The alar ti e a o l
.
TIME / PRESET
utto
utto
repeatedly to change the minute setting.
utto to o fir at the ti e a d the displa will stop
e set whe the radio is tur ed off. Press the ON /
utto for appro i atel
repeatedly to change the hour setting.
se o ds